How to maintain jaw crusher in production.I have summarized the following points, I hope to help you.

1. Regular dust removal, we all know that dust is impervious, and it will increase wear. When it falls on the electrical appliance, it will cause short circuit and leakage, so we must do a good job of cleaning the jaw crusher. We can use a wet cloth to wipe the place. If the dirt is not easy to wipe, we can wipe it with alcohol and a cotton ball.

2. Always pay attention to and lubricate the friction surface in time to ensure the normal operation of the machine and extend its service life. The grease used in the jaw crusher should be determined according to the place of use and the temperature. Generally, calcium-based, sodium-based and calcium-sodium-based greases are used.

3. When the jaw crusher is not in use, pay attention to check the wear of the internal components of the machine. If the cone cap, the central inlet pipe, the downflow liner, the impeller, the circumferential guard, and the wear block are found to be worn, the wear is more serious. Parts should be replaced and repaired in time. When replacing, you must pay attention to the weight, model and size of the components are the same as the original components.

4. The jaw crusher often causes the crash of the crusher due to improper use. Therefore, when crushing the material, we must pay attention to the uniformity of the material, and the hardness of the material is appropriate. If it is too hard, , You can add a process.